A wireless router usually includes a DHCP server, and the DHCP server is usually enabled by default on the LAN. To reach the WR management page, Admin must communicate on the network. You may also click Fast Forward Time just above the Connections selection box in the yellow bar. Note: If no green triangles are shown, make sure to enable Show Link Lights under Options > Preferences. When Packet Tracer displays green triangles on both sides of the connection between Admin and WR, continue to the next step. Admin is now connected to the LAN ( GigabitEthernet 1). WR will act as a switch to the devices connected to the LAN and as a router to the internet. Click WR and choose an available Ethernet port to connect the other end of the cable. When the cursor changes to connection mode, click Admin and choose FastEthernet0. Click Copper Straight-Through, represented by a solid black line.ī. Select Connections, represented by a lightning bolt, from the bottom-left side of Packet Tracer. Connect Admin to WR using a straight-through Ethernet cable through the Ethernet ports. Instructions Part 1: Connect to a Wireless Router Step 1: Connect Admin to WR.Ī.
#Script to send the test packet via wireless packet sender update#
Furthermore, you will also update some of the default settings. In this activity, you will configure a wireless router and an access point to accept wireless clients and route IP packets. Update default router settings Introduction.Add an AP to the network to extend wireless coverage.Connect a wireless device to the wireless router.Connect a wired device to the wireless router.13.1.10 Packet Tracer – Configure a Wireless Network Objectives
0 kommentar(er)
